Tips On Remedial Of Some Common Cake Faults

158

It is often the case that cakes are made which are not up to the required standard. When this happens, it is important to be able to identify what went wrong in order that you do not make the same mistake again. What follows is a list of the most common faults and their causes…

 

Cake sunk in the middle

Most of the causes for a sunken cake are concerned with recipe imbalance. Too much of a certain ingredient can cause the cake to rise quickly but then collapse (too much baking powder) or can result from an imbalanced recipe preventing sufficient air being beaten into the mixture (flour too soft, too much fat). The most common causes are as follows:

1. Too much baking powder

2. Too much sugar (this will be apparent if the cake also has a crisp, sugary crust)

3. Too much Fat/Margarine

4. Flour too soft

5. Cake was knocked in the oven before it had set

 

Cake collapsing at the sides

This is also called the ‘X’ fault on account of the shape of the cake after it is baked. Most often the cause is too much liquid in the batter inhibiting the batter from rising evenly.

 

Fruit sinking in the cake

A very common problem and one which can have a number of causes, either to do with the fruit or the batter. The most common causes are:

1. The flour is too soft

2. The batter is too soft

3. The batter is too lightly aerated (either from overmixing or from too much baking powder)

4. Fruit is wet and therefore heavy (especially cherries)

 

Cakes too small

A very common problem, and again one with a number of potential causes, the most common of which are as follows:

1. Insufficient aeration (from undermixing or not enough baking powder)

2. The batter is too stiff

3. Flour is too strong

4. Batter toughened (from overmixing or from recipe imbalance)

5. Oven too hot (which leads to the cake being ‘gripped’ and stunted)

 

Badly cracked tops

The cause of this is that the oven is too hot, and the crust of the cake forms while the cake is still rising, leading to the crust ‘bursting’

 

Peaked top

Usually caused by a tough batter, which is caused by overmixing, and is often accompanied by a long hole in the cake.

 

Wet streak at the base of the cake

This is caused by too much liquid, with the excess liquid in the recipe left as residue at the base

 

Cake staling quickly

This has a number of causes

1. Oven too cold so the cakes are in the oven too long, and the crumb dries out

2. Too much baking powder

3. Not enough liquid in the batter to keep the cake moist

 

Sugary tops or white spots on cakes

The causes are as follows:

1. Too much sugar

2. Not enough liquid (to dissolve the sugar)

3. Sugar too coarse (to be fully dissolved)

4. Cakes standing too long before going in the oven. This allows moisture to escape from the top of the cake, and leaves sugar residue in the batter.

 

Curdled cake batter

Fat and water do not mix normally, and in a cake batter which contains fat and water (in the eggs) there is a natural tendency for curdling, the breaking down of the emulsion of fat and eggs. If a cake batter curdles, then the cakes are often still acceptable, though smaller than usual. Curdling will occur if:

1. The eggs are added too soon before the fat and sugar have been creamed

2. The eggs are added cold, as this causes the fat to harden again, and accept no more eggs. Egg temperature should be approximately 72F (21 Centigrade)

3. The eggs are added in too large amounts. Eggs should always be added slowly and gradually.

Cakes often have faults but they can usually be avoided by taking basic precautions and ensuring recipes are balanced.

LEAVE A REPLY

Please enter your comment!
Please enter your name here